OK, here's my problem.
I had a weld done on my 1996 Volkswagen Jetta GL (2.0L Engine - 5 Speed Transmission)
and after the weld was completed I didn't get 1/4 mile down the road and my Jetta went
effing INSANE.
My gauges were going nuts, my RPMs were flying around, check engine light was...
Im trying to buy an ECM from this website http://www.autocomputerexchange.com/Product/93 for my dodge dakota 1998 and it asks you for vin # and mileage and part number.
thing is we have changed the original ECM for an autozone ECM twice and we called the website and the part number was suppose...
...to get it reprogrammed ? I know the numbers must match up, but I was wondering was it going to have to be reprogrammed and if so approximately how much does reprogramming cost?
i bought my toyota corolla at a used car dealership, but i just learned about the toyota recall on the corolla's. Can i still take my car to the toyota dealership in order to fix my car will i have to pay becuase i didnt buy the car from there?or should i be covered because it's a recall>
coil on it dos not have spark? Hi gay s my girlfriend 2004 Nissan sentra 1.8 s the ecm not turning the ignition coil on it dos not have spark end I change the coil +plugs and injector and still cod cilinder nr 4 misfire what could be the problem thanks Robert
I have a 91 chevy 4X4 that i blew the engine in 4.3l V6 manual and swapped it with a 95 5.7l V8. Auto trans. Now that i have engines swapped and sure that all wiring is plugged in when i try to start it there is no fuel coming out of the injectors. I took a ecm computer out of a 91 chevy 2X4...
Ok, so I have a 2000 Dodge Neon. It idled horrible for about 20 seconds before completly dieing on me. Since then I have replaced the ECM (PCM). It sounds like it wants to start but it just wont. The motor will turn over but it wont start. Im thinking I need to program the ECM. My dad said its...
I noticed that my 1990 Honda accords speedometer bounces around sometimes, or stops working completely. Sometimes it works perfectly fine. When it does not work the "S" light starts to blink. I did some research and found that it has to do with the Transmission trouble codes. Apparently you have...
My buddies Snap-On reader says the ECM is bad but everything else reads fine. It's a dealer only item that costs over $700. The truck has been running fine for over 1000 miles since the light came on. Should I worry? Can I have the current one flashed and it will work right again? Help....I...