I have a 1997 K2500 and the front seat (the sliding bench that is for the driver and the middle passenger) won't stay forward. It always slides back. I do have two springs for the seat that came with when I purchased the truck but I don't know where they go or if that is the fix. This is very...
my gmc is loosing the signal from the icm, The injectors are not activating. I have fuel pressure, I have spark, the pick up coil tested out good, i replaced the icm, and the ecm. I replaced both fuel sensors on the fire wall. the ignition coil is working fine. I had a electrical short out under...
my gmc is loosing the signal from the icm, The injectors are not activating. I have fuel pressure, I have spark, the pick up coil tested out good, i replaced the icm, and the ecm. I replaced both fuel sensors on the fire wall. the ignition coil is working fine. I had a electrical short out under...
I've recently replaced the motor (350 4-bolt main) and everything is working as it should, but the temperature is getting too hot around 235 or 240 degrees and sometimes goes into the red zone. I've replaced the thermostat with a new unit and have new antifreeze and the system is full, but it is...
i have a doozy for anyone that wants to take a stab at this. i have a 92 chevy 3/4 ton with the 6.5 litre turbo diesel in it and it has had transmission work done to it but here recently when ever you go down the highway in 2wd the tranny feels like it is slipping but as soon as you put it into...
I have a 1993 Chevy k2500 5 speed with a 5.7L engine. My problem is that when I start the truck after about 5 mins of driving it over heats to a little over 200 then drops back down to proper operating temp. This happens every time I start the vehicle. After the temp drops back down it doesn't...
Hi I just recentlly purchesed a 1988 Chevy K2500 4X4 350 5.7l with a 3 spd with low range i am new to 4wd i do not have the front shaft in it right now the reason is sitting still I can get the lever on the floor to go into 4 hi but i can not get the lever to go in to 4 lo any ideas on what is...