to the back of the bell housing? i am swapping the engine out of my glastron v-177 for a vw air cooled engine the original engine was a penta inline 6 in-board
I recently inherited a boat that has a volvo penta aq130. I am pretty sure the block is cracked near one of the head bolts. What is the best way to find out for sure and whats the easiest way to repair it. Also if I do end up replacing it what other engines will bolt up to the outdrive. I think...
This motor truns over but sounds like it sruggleing to start it's been siting for 1 1/2 years the silanod has spark. It's getting gas what can I try to start it. This motor is in a boat
The motor turn over but sounds alittle like it's sturggleing to start does'nt turn over freely. I can turn the motor by hand, getting spark to silanod. Boat set for 1 1/2 years. What should I try.
I was wondering if anybody had any input on the Volvo Penta 5.0L GL engine vs. the Volvo Penta 5.0L GXI for boat usage? Which was better which is preferred.
It goes Solenoid, resistor then distributor. I need a resistor for my motor and need the right resistor with the right ohms. Its a volvo penta B30 6 cylinder marine motor 170AQ. The resistor says made in Germany but I just need the ohms and would buy one in america if possible.