Ok, this is odd. I had and error code for lose of cam/crank sensor. So, i have replaced the cam sensor, computer, idle air, battery, done the screw fix i have read about, and the crank sensor was just replaced before i purchased this jeep. Now i noticed that the screw was not put in holding the crank sensor. So,,i got a bolt and put it in. once its tightened down. it shuts down the whole engine. so i let it set and put it in, pulled the battery cables to reset computer. it will not start... what is going one.....
Well, once the sensor is unscrewed and seeing turn slightly away from the bell housing it will start an run (until original error comes back). Plus does the rubber part have to be on there and the paper i have read about. Both are not part of the new sensor i just got.
Well, once the sensor is unscrewed and seeing turn slightly away from the bell housing it will start an run (until original error comes back). Plus does the rubber part have to be on there and the paper i have read about. Both are not part of the new sensor i just got.