when i turn the key it will start rev to 1000rpm then cut out when it dose start and ticks over it ticks at about 500rpm and sounds realy rough like it wants to stall but no check engine light. iv replaced the fuel and air filter spark plugs air flow meter cleaned the icv but still no joy any help
Here is the full recap (finally!) of Ugly Betty episode 3.14 - A Mother Of A Problem. On second viewing, I liked this episode more than the first time. One of the commentors was right, the episode was pretty much well written and acted. I thought Ignacio’s enthusiasm for Archie was a little...
further to my last question i have now had new plug and air filter changes along with oil but my car is STILL backfiring occasionaly and will SOMETIMES not rev over 2500 therefore it has no power to drive help?
I've had experience with both these engines...I've ran the absolute hell out of both, and both have never let me down. Do you have any stories about running the hell out of either of these engines? Do tell! Which engine is tougher??
any prob. with the trans.? i have a 92 dakota 4x4 with a bad head gasket n posible bad head and valves can i put my old truck motor that is a 6 cyl. 2 wheel drive in my eight cyl. truck without switching any thing but the motor of course and the computer
small town snowmobile club with a problem please help. is carb running out of fuel? at half throttle 3800 rpm, more throttle no rpm gain. we need more throttle and rpms to pull drag. we did a tune up plugs filters wires cap button. Could this ethanal fuel have loosened grime in carb? we are...
one of the indicator lights is on, i can not locate in service Manuel what the indicator light is for...
a round circle with what looks like tire tread on the right and left side of the circle......
I ask because I just bought a 66 owens 30' cabin cruiser with twin 318's (obviously). The previous owner said that her port motor had a blown head gasket, and when I fired that motor this weekend I heard a rod knocking HARD! (big surprise) I have paid through the teeth a few times for rebuilds...
If you mean a basic engine swap, then yes. The block and basic components will bolt up to trans etc with no problem. If you want to go full bore swap then you'll need to change the wiring harnesses and computer also.
Struggling to find a manual and its saying sim invalid its brand new never used and i have tried 3 different uk network sims in it and having the same problem when i put in each of them. would be grateful if anyone has a manual.
sometimes when i shut it off then try to restart i have to hold the pedal to the floor just like a flooded carb,it is TBI,what would cause this,I am a pretty good shade tree mech. but this has me STUMPED.
I have a 2000 BMW E46 318 saloon. I haven't managed to set off the alarm even when I try to do it intentionally. This leaves me to question whether or not it actually has an alarm system.
I've tried:
1. Locking the car with the key fob, and then opening the door with the key (I tried this with...
Hi,
I've just bought an L reg BMW 318i S E36 and on the way home I tried to see what it could do and it wont rev past 4500 revs?
On the dial it just bounces and it sounds like I've taken it to 6000 revs.
It's got 12 months MoT and full service history.
What could be causing this?
Thanks...
...window in the tr? I just bought this car and the window had been broken and replaced, but it will not stay on the track at all. The regulator appears to be attached incorrectly. how do you adjust it?
I have a 1994 Jeep Grand Cherokee that needs a new 5.2L motor. I have found a 5.2L short block with heads that is out of an 85 Dodge. Will the 85 5.2L and heads work in my 1994 Jeep?
hi all, im 21 years old and i want to buy a sporty looking BMW, E46 series. as i cant afford the M3, i would like the 318 m sport..and im wondering if this model has the exact same body kit as the real M3 model? also would it be possible for me to later add 4 exhausts and a M3 badge to the 318...