I have a 2000 Mitsubishi Eclipse that has a faulty ECU. I was able to find a replacement one with the same part number which I believe would work. My question is if I need to get the same immobolizer from the car that the new ECU is coming from. I was also told that it may be possible to have...
I recently purchased a 2000 Volkswagen Jetta with a VR6 engine. I noticed the engine rev's very high before needing to shift (60 MPH in second gear). However, I do not need this much torque. I am fairly certain the previous owner had flashed the computer on the car. My question is, how do I...
Is it possible to reset your ECU and perform the Throttle Pedal Release and Idle Air Volume using a scanner instead of the current G 35 process thats posted on the internet?
I have problem with my Opel Vectra C 2003 1.8 90KW Z18XE ECU.
I visited Opel dealer and they suggest me to replace ECU.
Diagnostics showed two codes:
P0203 Injector Circuit Malfunction - Cylinder 3
P0303 Cylinder 3 Misfire Detected
Car is running bad, engine power is fluctuating. Fuel...
...to get it reprogrammed ? I know the numbers must match up, but I was wondering was it going to have to be reprogrammed and if so approximately how much does reprogramming cost?
1999 citroen saxo? i had it checked out at garage and he said key and chip ok,immobiliser ok but not picking up ecu unit? how much new fitted? or would it be worth getting off a scrapyard?
its original key,need quick help? i lost my orginal key and cant find spear so am tryin to figure out how to start it while its parked in the garage . i read about replacing the ecu that goes with a lancer key and it will start right up or flashin the ecu and also resetting the immoblizer code...
so i bought this mazda rx7 car wont start but the guy told me it use 2 run but then he conected the battery back words. so i think its the ecu any advice and where is the ecu located