rpm

...successfully attach a pocket bike clutch to? The Victa lawnmower i think is either a 125cc or 160cc 2 stroke. I want to attach a standard 49cc pocket bike clutch and drum to it. Im not sure if the Victa would have enough power and produce enough rpm? thanks

...successfully attach a pocket bike clutch to? The Victa lawnmower i think is either a 125cc or 160cc 2 stroke. I want to attach a standard 49cc pocket bike clutch and drum to it. Im not sure if the Victa would have enough power and produce enough rpm? thanks

...successfully attach a pocket bike clutch to? The Victa lawnmower i think is either a 125cc or 160cc 2 stroke. I want to attach a standard 49cc pocket bike clutch and drum to it. Im not sure if the Victa would have enough power and produce enough rpm? thanks

...bike motor if so how? i wanna no because i found one around the garage and it has like 3 wires could i wire that to my motor for it to work please help me if this is the wrong category please tell me which one to put it in

...constant amount of gas what is this? it does fine when the rpms are higher like going in to another gear.even at idle it acts like it will die and the rpms always fluctuates no matter what. idk if it could be the o2 sensor, throttle positioning sensor or what but it is really bugging me it...

i have ridden bikes bikes before but they have all been 600's, after crashing one i havnt been on a bike in over a year. i recently decided to buy a 250 and i was told not to take it over 5000 rpms for the first 500 miles and not over 10000 rpms the next 500 miles after that? how accurate is this?

...but most of the time it swings? throttle neck is cleaned.as well as the fuel filter. this runs for already 3 to 4 months

...normal but most of the time it swings? throttle neck is cleaned.as well as the fuel filter. this runs for already 3 to 4 months

Lol sorry for my stupidity. I've heard it so many times but I just don't know what it is....

I Have a D-10 military blazer (cucv) I installed a new Vacuum pump, trans modulator and a shift kit (really just higher pump pressure spring) The truck shifted at 20-23 mph and 30-34 mph. Good firm shifts and no problems. One night it started not to up shift till 45 mph and then at 60 mph. I...

...chevy z71 120,000 miles? I have to push on the gas very slowly or the rpm's will go all the way to 4000 rpm's before switching out of first gear. Also when I go 70 mph my rpm's stay just above 3000 rpm's. What do you think?

the engine seems smooth in first gear and second and then when i am cruising in 5th gear at 1500-1800 rpm about 40-45 mph. the engine seems to be shaking or vibrating. i notice this from my steering wheel. It shakes at that speed and rpm speed. but after that there is no vibration. And its...

HI sounds like your having timing problems.. or its not getting fuel.. if it just bogs down I'd think on the not getting fuel ... if it miss and back fires then I'd say timing.. good luck tim

i tried another set of carbs, checked the ignition advance, checked ignition timming and cam timing, it starts instantly. any body ever heard of the pick ups not working at high rpm? all the pipes get hot quick, i am running out of ideas... how about a little help.

band no matter what gear...? this happens in any gear. the turbo (i assume) kicks on and off. it misses more after the turbo should be kicking in. could this be a sensor?

1987 Nissan 300zx non-turbo 168k miles. I cleaned and degreased the engine which is what I believe has caused these issues: At first it would just stall while idling. Now it won't rev over 2000 rpm but idles fine. It caused me to pull over on the shoulder of the road near my school this morning...

I took out Pop's brand new 2009 Lexus IS250 for a drive because he was out of the country... though I was careful at first, later that night I drove 120 mph coming back home. I'm now worried that I could have voided the warranty. May someone please give me information about this!?

...pushing the gas pedal? There is no whole in the throttle and its not stuck, what might be wrong

HELP, my civic won't pass inspection! Engine putting out too much pollution! Any relatively cheap solution to fix this problem? (other than buying another used car) Engine flush? << any use for doing this? Take it to the junk yard and get a new one? < no, no dinero! especially in this economy...

is there a good engineering site online to shop around for components? I suppose the motor would just have to be in the 20,000 range (it doesn't have to be exactly specific) and be able to attach a digital variable speed dial type thing would Radio Shack have stuff like this? an amateur project...