i got anew pyle subwoofer for cheap and im looking for a box for it and im buying it from amazon but the one i want is a sealed box and i wanted a ported box so if i bought the sealed box can i cut a small hole in the box and will it sound as good as a ported one?
i have a venom 10" 200WRMS subwoofer, would the Kenwood KAC-M525 amplifier get decent sound from the sub?
kenwood AMP specs
Maximum Power Output 350W
Cast Aluminum Heat Sink Design
Power MOS-FET Switching Power Supply
Built-in Low-pass Filter 80Hz (-12dB/oct)
2ohms Load Capability
Speaker...
I have 2 JL W7's running off 2 JL 1000/1 Mono Blocks with all 0 gauge wiring and wanted to know if i should port the box or not! I dont want just pure bass that hits hard but sounds shit! I want it to be as clean as possible and loud. Which would be better?
i got my car subwoofer, no in its box and took it into my room where i wired it up to a dvd player, the output of the dvd player thingo says 8 ohms in the woofer spots, and a lable on the back says 200-240V 50/60Hz 50W.
My subwoofer, 250RMS 1000max at 4 ohm.
i turned the volume up fully and...
Currently, my car has pioneer front and rear speakers and are all hooked up to my 4 channel amplifier. I am planning on adding a 12 inch mtx jackhammer subwoofer to my audio set up. I am aware about replacing my power cable from the battery to a bigger cable maybe a 4 AWG and just using a power...
Currently, my car has pioneer front and rear speakers and are all hooked up to my 4 channel amplifier. I am planning on adding a 12 inch mtx jackhammer subwoofer to my audio set up. I am aware about replacing my power cable from the battery to a bigger cable maybe a 4 AWG and just using a power...
where can I buy large custom foam or where can I have an applicant custom made for a deep excursion subwoofer?(double thick preferably)leave links if possible.thanks
Well at te moment i have a 350W subwoofer connected to my surround sound, but it is broke abit, it keeps ratteling :(. Anyway ive ordered a 1000W subwoofer to replace my other one. Ive been told i might need a amplifier for it???? But my old one is just connected by cutting one of my speakers...
i recently bought a PYLE PLW10BL 10 inch subwoofer driver, but i have no idea on the demensions to build a box for it. i have tried the "AJ vented designer program" but i keep getting an error that the Qts(or something similar) is too small, or big, i forgot. and the value for Xmax i have no...
i recently bought a PYLE PLW10BL 10 inch subwoofer driver, but i have no idea on the demensions to build a box for it. i have tried the "AJ vented designer program" but i keep getting an error that the Qts(or something similar) is too small, or big, i forgot. and the value for Xmax i have no...
changing the headunit..? i have the factory fitted audio system..it doesn have sub-out option..but need to install woofers ...is it possible to join the amp to the speker-out wire...
Changed the signal cable. Tried different digital 5.1 sources. Hooked up PC 5.1 sound card to the six inputs for the DVD 5.1 analog input. Only sound from the SW is when I put my ear directly in front of the front port, I hear a faint, low-pitched hum.
Just put my system into my new car and now I get a constant thump even at low volume and I only have my amp 1/4 of the way up and when I turn it up past the 1/4 mark it just beats repeatily waht is causing this I tried a rca loop but I get no signal with it pluged in its in at head unit going...
i was looking at buying a used subwoofer and 180 watt amp kit for my car. the seller is providing the box that houses the speakers and the built in amp. i was wondering what besides the box i would need to complete the installation,
would i simply be able to reroute my existing speaker wires...
Looking to purchase a 2 subwoofers and an amp for my car. Haven't looked into it to much, but could anyone give me a few suggestions for a good setup I could get for around $300? thanks
well i got given a subwoofer 800watt and a 200watt amp together, and i was just wondering how i would be able to hook it up with other speakers..... i heard you can use a car battery to power the amp and im just wondering how i would do that??? please tell me....josh
The iMac CS: A Coffeemaker, Subwoofer and Mac Mini All-In-One. You don't even know why you want it.
This isn't modder Klaus Diebel's first experiment with the iMac case. In the past he has also used it to create a mailbox and a birdhouse. However, this design is far more ambitious—allowing you...