Can't seem to get the '97 Suzuki RF900 to run... Cleaned the carburetors without synchronizing. (Don't have the tool...) I've tried spraying a squirt of Engine Starting Fluid directly down the chambers, with the carburetors off. IT REVS!! I just can't seem to get it to run/idle. I had...
...Lexus IS300? My 2005 Lexus IS300 is close to 90K miles and I believe the timing belt/water pump should be replaced. I have priced this with several dealers and mechanics and at this time I can't afford close to $1000 to have this done. However, I see there are kits that can be purchased for...
My dad passed down his 944 bit has been sitting for about 8 years. I think he saud one of the pistons are bent and timing belt is fucked.. how should I go about starting up this car and is it worth it? What will cost look like?? Answer asap
ok so here's what happened.my friend has changed my timing chain and gears on my 1990 dodge dakota 2wd with the 3.9 liter v6.this model has 4 separate belts not a Serpentine.so when he is re assembling it he fails to put back on the tube thing that acts like a timing mark.so now we are having...
Wow, I am so frustrated. I changed water pump just as reg maintenance and this timing chain is kicking my butt!! Question.. Car was timed perfect, went to start it and it would not turn over. I heard something rattle... It was the timing chain; it jumped four teeth errrrrrr so here's my ques...
I just changed my head gasket and put back all the essentials and it wont start. I think its the timing but I am confused how to get everything lined up. I can`t seem to spin the pulley that`s connected to the crank to get the number 1 piston to move into position.
im almost done with a full rebuild of my 240sx and i realized that when i removed the distributer, i did not mark its position clearly enough. so i do not know what it was set to beforehand. i know that i need to have the #1 cyl at TDC, but i dont know how i should set the distrib. before start...
I have an i35 2004 and i just replaced the camshaft sensor due to failure error code. I cleared the check engine light then started driving it. It was good until i gave it some gas and then the check engine light came back on with the same camshaft positioning sensor failure error code. Would...
I am helping a friend put in a 1.8 opel engine in a 1989 opel monza. Can anyone please tell me how to set up the ignition timing?
Quite urgent. Any help is greatly appreciated
Thanx
Hes the situation, the timing belt was removed with all marks at tdc, while removing a camshaft, it turned about a 1/4 wayfrom tdc, will i have a bent valves, remember everything was set a tdc, crankshaft and both camshafts, and no timing belt on. just the one camshaft turned a 1/4 way.
up to operating temp? Its got 84k miles on it, when the truck is cold there is no noise only when warmed uo
the sound is coming right where the timing chain is located on the truck engine. any ideas?
Also if its the tensioners how long can i drive before replacing them?
up to operating temp? Its got 84k miles on it, when the truck is cold there is no noise only when warmed uo
the sound is coming right where the timing chain is located on the truck engine. any ideas?
Also if its the tensioners how long can i drive before replacing them?
up to operating temp? Its got 84k miles on it, when the truck is cold there is no noise only when warmed uo
the sound is coming right where the timing chain is located on the truck engine. any ideas?
Also if its the tensioners how long can i drive before replacing them?