timing

if you are replacing a distributor, do you have to reset the ignition timing?

if you are replacing a distributor, do you have to reset the ignition timing?

my timing belt is really loose. is there a way i can adjust the tensioner or something or do i really have to pull everything apart and replace the belt again

I already know that it costs $37 to get the timing chain and I began to look in to doing it my self but i was reading the directions and it said that if I was even off by one tooth that my engine would be damaged. so I don't really want to risk that. can anyone tell me how much it will cost to...

For Toyota cars, is the timing belt considered under "powertrain" or "basic" warranty? Thank you!

I am working on replacing the head, the book is telling me to put the timing chain back on 90 degree backwards!! What does that mean?

i just replaced the rod bearings, and all new gaskets.. I was wondering if i have my timing belt a bit off if it would spina nd hit my valves.. if it was off?... also would an O2 censor stop it from firing?. and wat can i do to fix my timin belt... to know its on right?

I want to get a 2003 toyota celica. It has 63800..is the timing belt okay?the owner has nver had problems with it

...comes out the carburator? 79 thousand miles just bought it but the person i bought it from removed the distributer from the motor and put it in poped the first pisten up and tryed to set it but in turns over pops out flames from carburater and i need help seting the timing

My timing belt broke on my 2003 hyundai sonata. I replaced the belt but the car still wont start. I was told that if i changed the belt but my valves were bent it would still run but it would be a loud knocking noise. I also need to know what parts to look up for the pistons and valves. i did...

Its a 98 Audi A6 2.8L engine... i know bmw uses a chain but i don't know much about Audis....

a random interval then 4sec? It is for a display so i need power for just a few seconds then off for a random interval max 5 mins then on for another few seconds constantly. I have looked everywhere

...the timing opening but its not? motorcycle timing

Okay, I am in the markey to buy a 1998-2002 accord. Of course the car will have upwards of 100,000 k on the odometer. Should i get the timing belt and water pump changed if the owner did not? Also, what else should i change while i do this? Just the water pump and timing belt?

Okay, I am in the markey to buy a 1998-2002 accord. Of course the car will have upwards of 100,000 k on the odometer. Should i get the timing belt and water pump changed if the owner did not? Also, what else should i change while i do this? Just the water pump and timing belt?

i changed the timing chain,lined all timing marks,and silver tabs on chain.i also put no1 piston on tdc with no1 wire,but it will not start.i followed the haynes manual exactly and it was running when i tore it down.do you have any advice?

my timing is off 180 degrees i dont have a timing lite..how do i set my timing?? can someone please help asap!!!

2.8 liter Engine.? I recently had pull the distributor out of my engine to replace the seal. I had bumped the # 1 piston to TDC before taking the distributor out but the timing is off little. It doesn't have the power it did and is drinking fuel.Someone told me that there was a wire you had to...

Okay, I got a carbed 347 ford engine with mechanical advance. I got the engine to top dead center. Now my question is how to set the rotor. The number 1 cylinder is the 1st cylinder on the passenger side right? Isn't the rotor supposed to be facing the number 1 cylinder for the distrib cap? The...

How many hours and/or how much would it cost to replace it?