A couple months ago I was reading an article in a Hotrod magazine that, said there's a rumor going around about a possible new Trans am, GM might be coming out with. The article said that this is mainly dependant on the new Camaro sales. Is this true, has anyone heard an update on this? Or...
one day my trans down shifted in two second and it stays in second now and it started pouring out trans fluid so i had all gaskets, new fluid filters, torque converter, bushing, pump, and shift solenoids changed and it still wont shift out of second and i have to keep reeving it a little to get...
I got this car for free but it needed a new engine so i replaced the old engine and put the new one back in the engine bay but the transmission won't engage any gears. it did the very first time and that was in revervse but then it wouldn't shift into anything. the linkage is ok to the...
...power and shifts too soon.? Check engine light was on and had diagnostic run and it came up: MAF sensor and throttle pos. sensor. I changed these and it stopped the car from dying periodically but now I have great loss in power and trans wants to shift into 2nd by 15mph and 3rd by 25mph and...
hello i have a 1996 vw golf. I was driving and realized it was a little hard to shift into 5th gear. But now my car wont shift into at all. Any help would be greatly appreciated.
Thanks
i took the whole rear end apart still wont drop, but even if i did drop it, its completly solid, u wont be able to clean it out the only whole is where the gas goes in, but it only goes in not out
any ideas?
theres still gas in it so a torch may not be the best idea, maybe drill a 1 inch hole...
where to find them cheap? part list: 1, 2 sleeve & reverse idler gear, all synch. rings, bearing kit, and seal kit. (all for 1998 vw jetta 2.0L 5-spd) thanks...
but if you go to 3rd it will pop in to neutral and not move for a few hours then when you try it again its fine im a women and was wondering do i need a new tranny or is it a part or computer asking causedon'tt want taken by the mechanic
hi i need to know how tight to shim the bearings on the input to output shaft on a Peugeot 5 speed trans in a 89 jeep cherokee. i know people say not to bother fixing these but money is tight and used Peugeot parts cheap. i put one together too tight and it trashed the bearing between the input...
does anyone know if it would be a good idea to install a supercharger on an acura rsx base model with an automatic transmission w/ sport shift? or if a turbocharger would be as good or a worse idea. if anyone knows a good place to buy either of these please help me out with that as well, thanks.
i have a van and my side door wont open it.It just happened one day i shut it and came backa and it wouldn't open.I've tried everything to get it open but it wont budge.Any suggestions on what could help me get it open before i pay alot to take it to the shop?
shift into any gears. HELP? replaced the trans fluid and screen and the truck doesn't seem to recognize it has a transmission at all. There was a leek for a little wile and the truck may have been pushed a little too far on low fluid, but still moved before the work was done, i know the clutches...
I have a 1987 Volvo 740 .The transmission will not shift to 3rd or 4th until it warms up ( about a mile of driving ) . It doesnt have an electic or vacuum module and I am completely new to Volvo's . Could it be the type of fluid ? Vacuum problem ?
Thank you for any tips you can provide , Sean
I am buying a truck I know it needs a trans and I plan to go to the local pullapart and get the trans I need to know what vehicles will have the same trans and will be a direct bolt on and fit the truck has the vortec 305 and a standard 5 speed trans thanx...
the truck is a 91 with 4 speed auto trans & 4x4 & a 318 5.2l v8 tbi (last year they made the tbi-so i know id have to switch wiring harness) but would the trans bolt up to this engine if i fabbed up motor mounts & hooked up the electronics-fuel lines-brake lines-ps-heater core-& coolant lines...