crazy4frogs80
New member
- Feb 26, 2010
- 1
- 0
- 1
my power vent will work fine if i blow out the standing flame thats still lit after it goes through a cycle. and when if i leave it lit when it starts up again it will turn blower on and not the main burner! but during all of this if i blow out the "pilot" it will start right up and finish its cycle. it has an electronic ignition so im confused at why it has that small flame after its done heating and the main burner shuts down. Please help need to find out what part i need to change, cant afford a new heater. thank you
the thermostat clicks main burner turns off and blower turns off, the small flame stays lit near the glow plug for pilot. if i leave the small flame lit and wait for the thermostat to click back on blower turns on but not main burner, if i blow out the small flame it starts glow plug pilot turns on and then main burner.
the thermostat clicks main burner turns off and blower turns off, the small flame stays lit near the glow plug for pilot. if i leave the small flame lit and wait for the thermostat to click back on blower turns on but not main burner, if i blow out the small flame it starts glow plug pilot turns on and then main burner.