take off bumper...cut out section where the fog lights need to go..but make sure you dont cut the studs where the screws need to go on...now place the metal bracket in to the cut out and screw it in...place the plastic cover on it and screw that on...replace bumper...drag the wires through the firewall and attach the wire to the provided switch...if no switch is provided then youll need to buy one...now ground the wire that needs to be grounded and drag the power wire from the switch to the battery and connect it...now your done...
i agree wit the first answer no need to remove the bumper
drill a couple of holes where the fog lights would go and then cut the sections out with a power jigsaw. use blue painters tape to keep the cut edge from fraying and take your time the lights will slide into the cut outs
then bolt the lights in with the screws & mounting bracket that should be on the lights itself