this question is about the seats in my truck?

S

Sarah

Active member
I currently own a toyota tacoma year 2006. I am looking to put in bucket seats because I hate my bench seat (I'm 5'3" and the rest of my family is about 5'7" and taller so their knees are in the dash board when they ride with me) My question is can I take bucket seats from a toyota 4runner with it's console and mount them into my car or do the bolts not match up and I'd have to drill new holes?
 
G

gearnofear

Member
you will need to drill new holes, the bench seats are only bolted on the sides of the bench. the bucket sets will need bolts on both sides of the seat. As for the center console, my advise would be to pull the carpet up and see what the center has. the holes may already be there, if not, you will need to drill. however for the center console, you can use self tapping screws to secure it to the tunnel
 
P

PitBullLady

New member
Why not just take the bucket seats and console out of another Tacoma and put them in there?
As far as bolt patterns matching up, you do have a truck with a bench seat so it's not going to have the proper supports for the bucket seats anyways. If you're ripping the seats out of another truck, take the entire seat setup including the floor mounts so that way you can bolt them down, and then just mount the seats like normal.
 
Top