trevorjanok
New member
- Jun 19, 2010
- 4
- 0
- 1
I have this 2CH AMP: http://www.bossaudio.com/main/827 - and two 400 RMS (800 Peak) subs.
I'm new to this, but how I currently have it setup, is each sub, uses it's own channel. Which if I understand correctly, is running at 4 ohms. But if I wanted to run at 2 ohms, would I run the subs in parallel, and than bridge the connections to the amp?
Also, wouldn't this be the preferred way to set it up?
I'm new to this, but how I currently have it setup, is each sub, uses it's own channel. Which if I understand correctly, is running at 4 ohms. But if I wanted to run at 2 ohms, would I run the subs in parallel, and than bridge the connections to the amp?
Also, wouldn't this be the preferred way to set it up?