JohnRussel
New member
I have a mono block amp that is 2000W peak and 500W RMS x 1 @ 4 ohm. I have two dual 10 Inch Subs that are 600W peak and 300W RMS a piece. So; should I hook up my subs in parallel or series?
Also, its not a problem that my amp's peak is higher than my subs as long as I have the gain turned down; right?
I have a mono block amp that is 2000W peak and 500W RMS x 1 @ 4 ohm. I have two dual 10 Inch Subs that are 600W peak and 300W RMS a piece. So; should I hook up my subs in parallel or series?
Also, its not a problem that my amp's peak is higher than my subs as long as I have the gain turned down; right?
AMP(BOSS AUDIO CX2000M)
Subs(BOSS AUDIO CX10)
Should I go with these subs? (http://www.newegg.com/Product/Product.aspx?Item=N82E16882010466)
If so I would run the voice coils in parallel and the subs in series. Right?
Also, its not a problem that my amp's peak is higher than my subs as long as I have the gain turned down; right?
I have a mono block amp that is 2000W peak and 500W RMS x 1 @ 4 ohm. I have two dual 10 Inch Subs that are 600W peak and 300W RMS a piece. So; should I hook up my subs in parallel or series?
Also, its not a problem that my amp's peak is higher than my subs as long as I have the gain turned down; right?
AMP(BOSS AUDIO CX2000M)
Subs(BOSS AUDIO CX10)
Should I go with these subs? (http://www.newegg.com/Product/Product.aspx?Item=N82E16882010466)
If so I would run the voice coils in parallel and the subs in series. Right?