white rogers furnace standing pilot?

[BOE3]

White Rodgers does not make furnace. Thats your thermostat

Anyway if you have pilot then the gas valve is fine.
If the furnace is fairly new it should have on board diagnostic via the control board. Its nothing more than a LED light. If you have that and its blinking. Count the # of flashes. On the back of the furnace panel or there is a fault code chart. So match the # of flashes to the chart. It will point you in the general direction of what the problem is. It wont tell you how to fix it though.

If the furnace is older and does not have this. Try turning the blower from auto to ON. If the blower does NOT come on then your furnace is in lock out mode.
If it comes on, and the thermostat has batteries replace them.
If still a problem your going to need to call a HVAC company to diagnose.

 

[Keith]

pilot lite but burners wont ignite

 

[ToolTimeTony]

Your question isn't as clear as it could be but it sounds like the pilot is lit but the burners won't come on. Possible reasons-

-the thermostat is bad
-the control knob on the gas valve is turned to the pilot position? Make sure it is pointing to ON
-the gas valve is bad or sticky-try rapping on it with a wrench lightly
-one of the doors of the furnace is off and the safety is not allowing it to come on. Make sure the lower door is on properly.
-check to make sure the power is on to the furnace--there should be an on/off switch on the side or the breaker box.