what if i wire my amp to 2 ohms and run it to 4 ohm sub?
idk if im saying that correctly, but hopefully you get what im saying.
(wire my sub at 2 ohms, when it says 4 ohm sub)
with the mini stereo system? Thank you!
Wires -- thank you. You answered my question. The units have the line-in and line-out so I will connect them. Neither manual was very clear on what could be connected.
I have not yet been able to figure out how to mark your answer as 'resolved'!! I'm...
Before you start reading, this is not for a car
I have a hybrid pre-amplifier with two 8 ohm speakers plugged in.
It works fine.
But I also do have an 18 inch 8 ohm sub thats 500w RMS and 1000w peak.
My pre-amp has sub outputs, but I need to get a power amplifier to power my sub. I have been...
A "gauge 8" jumper cable has a diameter d of 0.326 centimeters. The cable carries a current I of 30.0 amperes. The electric field E in the cable is 0.062 newtons per coulomb.
What electric field would have been required to create a current of 30.0 amperes in a copper "gauge 10" wire with...
ok, i want to know how to change the ohm on my system running on 2 channels i want to make it either 6 ohm or 4 so i can get more power to my 12's its a 500w yamaha but the speakers are a 6 ohm speaker. instead of running the pos and neg straight to the speakers pos and neg i want to run it...
I have two 4 ohm MTX car subs that I am connecting to my home stereo amp. It has an impedence switch on the back to switch between 4 or 8, but my bookshelf speakers have an impedance of 8 and the switch on the receiver is set on 4. How do I set it up?