solid Bad Brake Light Switch? The Brake Light was blinking and ABS was solid so I changed my front brake pads rotors and sensors. I noticed the front driver side sensor was cut so I had to rewire the sensor by hand.
After replacing these my brake light is blinking and ABS is solid. When I first start the car it beeps 3 times.
When I try to run a VAG-COM on the ABS and Brakes I get a error. Although I do get this message
Address 02: Auto Trans
Controller: 4B0 927 156 G
Component: AG5 01V 2.8l5V USA 8509
Coding: 00000
Shop #: WSC 00000
1 Fault Found:
00526 - Brake Light Switch-F
27-00 - Implausible Signal
Could a faulty brake light switch cause both the ABS and Brake light to appear?
Any other suggestions on this?
After replacing these my brake light is blinking and ABS is solid. When I first start the car it beeps 3 times.
When I try to run a VAG-COM on the ABS and Brakes I get a error. Although I do get this message
Address 02: Auto Trans
Controller: 4B0 927 156 G
Component: AG5 01V 2.8l5V USA 8509
Coding: 00000
Shop #: WSC 00000
1 Fault Found:
00526 - Brake Light Switch-F
27-00 - Implausible Signal
Could a faulty brake light switch cause both the ABS and Brake light to appear?
Any other suggestions on this?