How long should it take to replace a manual 4 speed transmission in 1995...

J

JKcDad

New member
...Toyota Tercel? Got a used tranny to replace one that is stuck in third gear. Will most likely reuse clutch (only 2 yrs/<14000 miles highway on clutch). Just want to know estimated time from start to finish to change over tranny. Thanks ahead of time
 
I

ibjammin2009

New member
you Doing it your self?? i can swap one out in a day if every thing goes like it should. if your having it done it all depends i took my Jeep to aamco cause its an Auto so i dont mess with that and it was there for 4 weeks thats Way too long but id say 2-4 days depending on how busy the shop is
 
I

ibjammin2009

New member
you Doing it your self?? i can swap one out in a day if every thing goes like it should. if your having it done it all depends i took my Jeep to aamco cause its an Auto so i dont mess with that and it was there for 4 weeks thats Way too long but id say 2-4 days depending on how busy the shop is
 
D

DavidR

Member
adjusting the pressure plate and bleeding the clutch cylinder, about 2-3hrs if your familiar with the configuration. but thats if you DIY.
 
G

ghostlystate

New member
It depends on how skilled you are and if you have the right kind of equipment. If you have a shop with a hoist you can do it a few hours, but if you don't then you are looking at a long time. If you are unsure of what to do then you can always take it to a shop, you shouldn't be attempting this if you are not sure what you are doing, it isn't a backyard mechanic job.
 
G

ghostlystate

New member
It depends on how skilled you are and if you have the right kind of equipment. If you have a shop with a hoist you can do it a few hours, but if you don't then you are looking at a long time. If you are unsure of what to do then you can always take it to a shop, you shouldn't be attempting this if you are not sure what you are doing, it isn't a backyard mechanic job.
 
Top